Crestron HD-TX-USB-2000-C Manual

DO
HD-EXT-USB-2000-C
4K HDMI and USB over HDBaseT
®
DO

Install the Devices

The Crestron ® HD-EXT-USB-2000-C consists of the HD-TX-USB-2000-C transmitter and the
HD-RX-USB-2000-C receiver. The transmitter and receiver can be mounted on a flat surface or onto
a rack rail.

Mounting onto a Flat Surface

Using four mounting screws (not included), mount the transmitter and receiver onto a flat surface
such as a wall.

Mounting onto a Wall

Mounting onto a Rack Rail

The transmitter and receiver can be mounted onto the front or rear rail of a rack. Position either the
left or the right mounting flange of the device so that the holes align with the holes in the rack. Then,
secure the device to the rack using two mounting screws (not included).
Mounting onto a Rack Rail
GUIDE
Extender 2000
®
DO

Check the Box

QTY PRODUCT
HD-TX-USB-2000-C
2 Connector, 2-Pin
1 Connector, 3-Pin
1 Connector, 5-Pin
HD-RX-USB-2000-C
2 Connector, 2-Pin
1 Connector, 3-Pin
1 Connector, 5-Pin
1 Power Pack, 24 Vdc, 1.25 A, 100-240 Vac
DO

Connect the Devices

Make connections to the transmitter and receiver as required.

Connecting the Transmitter

Make connections to the front and rear panels of the transmitter.

Front Panel Connections

HDMI IN:
From balanced/
From HDMI ®
audio/video unbalanced
source analog audio

Rear Panel Connections

:
Passive pass-through
to Ethernet port on
receiver
COM: COM:
To
To
RS-232 RS-232
device 2 device
2
PART NUM.
2049091
2049092
2049093
2049091
2049092
2049093
2045870
AUDIO IN: AUDIO IN:
From balanced/ (Host): (Device):
unbalanced To USB To USB
device host
analog audio
source source
1 1
HDBT OUT:
To HDBT IN port
on receiver
IR IN: IR IN: IR OUT:
To IR
From From
Crestron IR emitter
® Crestron IR 4
control port
control port
or other IR or other IR
signal source 3 signal source
3
IR OUT:
To IR
emitter
4