Table of Contents
Advertisement
16
www.raider.bg
sure lids and protective equipment are intact and are installed correctly.
6.1. Cleaning.
Easiest to clean your hair immediately after mowing. After working carefully clean the machine with
a soft brush and cloth. Do not use water and / or solvents and detergents. Remove any bits of grass,
especially from the vents. Place the machine on its side and clean the blade area. Work Always wear
gloves! Remove particles stuck firmly to wood or plastic block.
6.2. Sharpening or replacement of the cutting edge.
Replace dull or damaged blades. Blade is removed by bolt unscrewed the main center of the knife
with a wrench 36. Before inserting a new blade or after you have banished the old one, make sure
the blade is positioned correctly and both pins are put into holes in the knife. Beware! One pin is
irregularly cylindrical shape and can only come into the corresponding hole of the knife. This ensures
the installation of the only knife in the correct position. Then tighten the bolt again and make sure that
no gaps and the knife is installed correctly. Use only suitable for hair cutters.
6.3. Always clean the main hair when I leave for longer storage. Especially in winter. Grease a knife
with oil to protect it from rust. To save space, you can disassemble the top of the hair on the bottom.
7. Faults and correct them.
The table below shows symptoms of failure and how you can help if your hair is no longer working
properly. If you can not find and fix the problem by following the instructions in the table, contact an
authorized service Ryder. Warning: before removal of damaged hair and stop it off from the mains.
Faults
Mower does not
start to work
The engine is on,
but the knife does
not rotate.
Engine is turned off
suddenly.
Unusual noise.
Strong vibrations.
Unequal mowing.
Engine work
hard and reduce
turnovers.
Removal
Power cable is not connected or damaged
Mower is in a tall grass.
It is possible that the mower is fuzzy and
the blade is blocked.
Plug is withdrawn
Bolt is loose or the blade connections
between fasteners.
Distorted and damaged knife.
The grass is very high.
The knife is blunt.
It is possible that the mower is fuzzy and
blocked
The sword can be installed incorrectly. .
Reasons
Check cable. If necessary, replace it.
Upon initial release always put the
mower in the grass
Disconnect the plug and check it. Put
on your protective gloves and clean
the knife and release
Check cable. Make sure it is well
enshrined in prispoblenieto (16) and
plug it again.
Fasten the parts.
Immediately stop the mower and
replace the knife in a specialized
service.
Increase mowing height.
Replace or tipped knife. See 5.2.
Look underneath the mower and
clean it. Work always with protective
gloves.
Check. See 5.2
Advertisement
Table of Contents
