The appliance can be installed as freestanding or
•
below a kitchen counter with correct space (refer to
the Installation leaflet).
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from being
fully open.
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied
•
through an external switching device, such as a timer,
or connected to a circuit that is regularly switched on
and off by a utility.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
Ensure good air ventilation in the room where the
•
appliance is installed to avoid the backflow of
unwanted gases into the room from appliances
burning gas or other fuels, including open fires.
WARNING: Do not install the appliance in an
•
environment with no air exchange.
The appliance contains flammable gas, propane
(R290), a gas with a high level of environmental
compatibility. Keep fire and ignition sources away from
the appliance. Be careful not to cause damage to the
refrigerant circuit containing propane.
WARNING: In the appliance enclosure or in the built -
•
in structure, keep ventilation opening clear of
obstruction.
WARNING: Do not damage the refrigerant circuit.
•
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Do not exceed the maximum load of 9,0 kg (refer to
•
the "Programme chart" chapter).
ENGLISH
5