Table of Contents
Advertisement
24
www.electrolux.com
Error code
E97
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
14.2 Troubleshooting
Problem
You cannot activate the appliance.
The program does not start.
The appliance door does not close.
The appliance stops during operation.
The cycle time is too long or unsatisfacto‐
ry drying result.
Possible cause
Internal fail. No communication
between electronic elements of
the appliance.
The mains supply is unstable.
1)
The program was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.
Possible solution
Make sure that the mains plug is connec‐
ted to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pause.
Make sure that the appliance door is
closed.
Make sure that the installation of the filter
is correct.
Make sure that the laundry is not caught
between the appliance door and the rub‐
ber seal.
Make sure that the water container is
empty. Press Start/Pause to start the pro‐
gram again.
Load is too small, increase the load or
use the Time Drying program.
Make sure that the weight of the laundry
is suitable for the duration of the pro‐
gram.
Remedy
Advertisement
Table of Contents
