Logging Onto The Zvr-500; Osd Set-Up; Captions; Receiver Set-Up - ZoneVu ZVR-500 Manual

MZVR500.DOC
The ZVR-500 should now be configured by logging onto the receiver from a ZVK-XXX keyboard and
following the On Screen Menus.
It is important to configure the following ZVR-500 parameters in the following order before attempting to
configure any other parameters.
01 Where required set Presets = On for Pan,Tilt,Zoom and Focus
02 Check and set the Direction of Pan,Tilt,Zoom and Focus
03 Format the Head Pots.
04 Set End Stops = On for Pan and Tilt
05 Set the End Stops for Pan and Tilt
06 Set Head Inertia and Drive Level for Slow Speed control to suit the Pan & Tilt Head being used
2-1

LOGGING ONTO THE ZVR-500

LOGGING ON FROM THE ZVK-007 KEYBOARD
Access to Telemetry Receiver Configuration is achieved by logging on to the SUPERVISOR LEVEL of the
keyboard. For further information on how to log onto this level please refer to the accompanying ZVK-007
KEYBOARD MANUAL.
LOGGING ON FROM THE ZVK-008 KEYBOARD
Access to Telemetry Receiver Configuration is achieved by :-
01 Select the camera you want to log onto to.
02 Press the <*> key
03 Type ZVR and press the <#> key
For further information on how to log onto this level please refer to the accompanying ZVK-008 KEYBOARD
MANUAL.
The ZVR-500 receiver will now display the ZoneVu ZVR-500 menu with software release details followed by
the QUICA ZVR-500 menu.
Configuration is divided into five sections as follows.
ON SCREEN DISPLAY SET-UP

CAPTIONS

RECEIVER SET-UP

AUTO-POSITION

SPEED SET-UP

2-2

OSD SET-UP

This section allows the user to define the following aspects of the on screen display
DISPLAY POSITION
MEYERTECH LIMITED
ZoneVu
- Top or Bottom
ISSUE 01
ZVR-500 RECEIVER
6