Advertisement
STEP 17
Add a washer to each bolt, then starting with
the upper bolts, thread the bolts through the
stem faceplate into the stem body making
sure they are equally finger-tightened.
STEP 19
Using a torque wrench and the
corresponding hex bit, gradually torque
the upper bolts alternating from the
left to the right to evenly increase the
torque until the specification is reached.
1
2
STEP 18
Adjust the handlebar to the desired
position making sure it is centered.
STEP 20
2
Using a torque wrench and the
corresponding hex bit, gradually torque
the lower bolts alternating from the
left to the right to evenly increase the
torque until the specification is reached.
1
Advertisement
