NOTE:
Before working inside your tablet, read the safety information that shipped with your tablet and follow the steps in
Before working inside your
For more safety best practices, see the Regulatory Compliance home page at www.dell.com/regulatory_compliance.
NOTE:
Your tablet's Service Tag is stored in the system board. You must enter the Service Tag in the BIOS setup program
after you replace the system board.
NOTE:
Replacing the system board removes any changes you have made to the BIOS using the BIOS setup program. You
must make the desired changes again after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of the connectors so that you can
reconnect the cables correctly after you replace the system board.
Topics:
•
Prerequisites
•
Procedure
Prerequisites
1. Remove the
back
cover.
2. Remove the battery.
3. Remove the
solid-state
drive.
4. Remove the
wireless
card.
Procedure
1. Disconnect the docking port ribbon cable and docking port cable from the system board.
a. docking port ribbon cable
38
Removing the system board
Removing the system board
tablet. After working inside your tablet, follow the instructions in
25
After working inside your
tablet.