HP Compaq dc7100 DT Reference Manual page 182

Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
19. Install the new PCI riser card cage assembly on the new backwall by aligning the cage with
the guide rails on the backwall. Press down firmly on the cage to secure it in place on the
backwall. Be sure the riser card in the cage is properly seated in the PCI expansion slot on
the system board.
20. Slide the drive cage back into its operating position and lock it in place. Be sure to use proper
cable handling and placement precautions.
Ä
CAUTION: Cables are very sensitive. Overbending, creasing, or pinching can damage cables.
7–56 361288-003 Service Reference Guide, dc7100