Monte Carlo Fan Company 3IKR52 Series Owner's Manual And Installation Manual page 5

12
Blade
Washer
Set screw
Insert blade into the slot on the flywheel.
Install blade by the screws and washers
provided, aligning each of the holes as
shown and tighten all screws securely.
Repeat this process for remaining blades.
15
Loosen 2 and remove 1 preassembled
screws from light pan. Keep screw.
© 2021 Monte Carlo Fan Collections
13
Flywheel
Loosen 2 and remove 1 preassembled
screw from the plate on motor. Save
screw for later use.
16
Color temperature
converted switch
Connect white wire from fan to white wire
from LED light fixture and then connect
blue (or black) wire from fan to black (or
blue) wire from LED light fixture. Be sure
plugs connection clasped together firmly.
Attach LED light fixture onto the light pan,
aligning the keyhole slots on the LED light
fixture with the preassembled screws on
the light pan. Twist clockwise till lock.
Reinstall the screw which was just
removed. Tighten all screws securely.
This light kit includes 2700 (Warm white),
3000 (Soft white) and 4000K (Daylight)
correlated color temperatures (CCT). Get
desired CCT by operating the converted
switch.
14
Plate on motor
Place the lead wires from fan over the
central hole of light pan.
Aligning the keyhole slots on the light pan
with the preassembled screws on the
plate. Twist clockwise till lock. Reinstall
the screw which was just removed.
Tighten all screws securely.
17
light fixture
Attach light shade by locating dimples in
light pan with grooves on the light shade
and twist clockwise until tight.
5
Light pan
Light shade
11/2021