Account/Audio Settings - Grandstream Networks WP810 Administration Manual

Caller Request Timer
Callee Request Timer
Force Timer
UAC Specify Refresher
UAS Specify Refresher
Force INVITE
Security Settings
Check Domain
Certificates
Validate Certificate
Chain
Validate Incoming
Messages
Check SIP User ID for
Incoming INVITE
Accept Incoming SIP
from Proxy Only
Authenticate Incoming
INVITE

Account/Audio Settings

Preferred Vocoder
Use First Matching
Vocoder in 200OK SDP
If set to "Yes" and the remote party supports session timers, the phone will
use a session timer when it makes outbound calls. The default setting is "No".
If set to "Yes" and the remote party supports session timers, the phone will
use a session timer when it receives inbound calls. Default setting is "No".
If Force Timer is set to "Yes", the phone will use the session timer even if the
remote party does not support this feature. If Force Timer is set to "No", the
phone will enable the session timer only when the remote party supports this
feature. To turn off the session timer, select "No". The default setting is "No".
As a Caller, select UAC to use the phone as the refresher; or select UAS to
use the Callee or proxy server as the refresher. The default setting is "Omit".
As a Callee, select UAC to use caller or proxy server as the refresher; or
select UAS to use the phone as the refresher. The default setting is "UAC".
The Session Timer can be refreshed using the INVITE method or the
UPDATE method. Select "Yes" to use the INVITE method to refresh the
session timer. The default setting is "No".
Choose whether the domain certificates will be checked or not when
TLS/TCP is used for SIP Transport. The default setting is "No".
Validate certification chain when TCP/TLS is configured. Default setting is
"No".
Choose whether the incoming messages will be validated or not. The default
setting is "No".
If set to "Yes", SIP User ID will be checked in the Request URI of the
incoming INVITE. If it does not match the phone's SIP User ID, the call will
be rejected. The default setting is "No".
When set to "Yes", the SIP address of the Request URL in the incoming SIP
message will be checked. If it does not match the SIP server address of the
account, the call will be rejected. The default setting is "No".
If set to "Yes", the phone will challenge the incoming INVITE for
authentication with SIP 401 Unauthorized response. Default setting is "No".
Multiple vocoder types are supported on the phone, the vocoders in the list
is a higher preference. Users can configure vocoders in a preference list that
is included with the same preference order in SDP message.
When it is set to "Yes", the device will use the first matching vocoder in the
received 200OK SDP as the codec. The default setting is "No".
WP810 Administration Guide
Version 1.0.7.83
P a g e | 41