Grandstream Networks WP810 Administration Manual page 38

SIP T2 Timeout
SIP Transport
SIP Listening Mode
SIP URI Scheme when
using TLS
Use Actual Ephemeral
Port in Contact with
TCP/TLS
Outbound Proxy Mode
Support SIP Instance
ID
SUBSCRIBE for MWI
SUBSCRIBE for
Registration
Enable 100rel
Callee ID Display
SIP T2 Timeout is the maximum retransmit time of any SIP request
messages (excluding the INVITE message). The re-transmitting and
doubling of T1 continues until it reaches the T2 value. Default is 4 seconds.
Determines the network protocol used for the SIP transport. Users can
choose from TCP, UDP and TLS. The default setting is "UDP".
Based on option "SIP Transport" and this option "SIP Listening Mode", phone
will decide which transport protocol it should listening to from the incoming
request. The default setting is "Transport Only".

Transport Only

Dual

Dual (Secured)

Dual (BLF Enforced)
Specifies if "sip" or "sips" will be used when TLS/TCP is selected for SIP
Transport. The default setting is "sips".
This option is used to control the port information in the Via header and
Contact header. If set to No, these port numbers will use the permanent
listening port on the phone. Otherwise, they will use the ephemeral port for
the connection. The default setting is "No".
The Outbound proxy mode is placed in the route header when sending SIP
messages, or they can be always sent to outbound proxy.
Defines whether SIP Instance ID is supported or not. Default setting is "Yes".
When set to "Yes", a SUBSCRIBE for Message Waiting Indication will be
sent periodically. The phone supports synchronized and non-synchronized
MWI. The default setting is "No".
When set to "Yes", a SUBSCRIBE for Registration will be sent out
periodically. The default setting is "No".
The use of the PRACK (Provisional Acknowledgment) method enables
reliability to SIP provisional responses (1xx series). This is very important to
support PSTN internetworking. To invoke a reliable provisional response, the
100rel tag is appended to the value of the required header of the initial
signaling messages. The default setting is "No".
When set to "Auto", the phone will update the callee ID in the order of P-
Asserted Identity Header, Remote-Party-ID Header and To Header in the
180 Ringing. If "Disabled", callee ID will be displayed as "Unavailable". When
set to "To Header", caller ID will not be updated and displayed as To Header.
WP810 Administration Guide
Version 1.0.7.83
P a g e | 38