Measuring With The Rack Template - HP BladeSystem bc1500 Setup And Installation Manual

Installing and Cabling the HP CCI Solution

Measuring with the Rack Template

Å
4-2
Using the rack template, identify the proper holes for inserting the
tabs on the vertical rack supports. Use a pencil to mark the top and
bottom edges for the rack supports on the rack template, which
identify the position for the rails supporting the enclosure.
To use the rack template to identify the required space and location
for the enclosure:
1. Stand at the front of the rack and identify the front side of the rack
template.
2. Starting at the top of the last item installed, secure the rack
template against the front of the rack by sliding the two push tabs
into the holes in the rack supports.
WARNING: Racks must be adequately stabilized before and after
product installation. If you are installing an enclosure into an empty rack,
you must install the enclosure at the bottom of the rack and work your
way up with additional enclosures as needed.
IMPORTANT: Match the hole pattern on the rack template with the
holes in the rack supports.
Measuring with the rack template
www.hp.com Setup and Installation Guide