Cabling The Hp Cci Solution - HP BladeSystem bc1500 Setup And Installation Manual

Cabling the HP CCI Solution

Setup and Installation Guide
To load the enclosure into the rack:
1. Refer to the "Measuring with the Rack Template"
chapter.
2. Stand at the front of the rack.
3. Align the bottom of the enclosure with the top of the rack rails.
4. Slide the enclosure fully into the rack 1.
5. Tighten the thumbscrews to secure the enclosure in the rack 2.
Installing the enclosure into the rack
An HP CCI solution requires no internal cabling. External cabling is
achieved through the interconnect switch installed in your solution.
The procedure for cabling an enclosure consists of the following
steps:
■
Identifying the interconnect switch connectors
■
Cabling the blade enclosure
www.hp.com
Installing and Cabling the HP CCI Solution
section in this
4-9