Wacom Cintiq 24HD Important Product Information page 7

Contents
Always support the display with one hand before releasing from the locked position.
Do not hold the support arms when releasing the lock.
The display comes down when the lock is released. As the display moves downward,
ensure that your fingers are not caught between the support arms and base of the
display or stand.
Ensure that cabling or other objects do not get entangled in the moving parts of the
stand.
Do not place this product on any wet surface or table. The rubber pads on the base of
this product may slip, allowing the product to fall from the surface.
When moving this product, ensure all cables are fully disconnected from the power
outlet, computer, and other areas. Appropriately bundle the cables to ensure they do
not hang free and create a hazard. Tripping over loose cables can cause physical
damage or personal injury.
This product weighs approximately 30 kg (66 lbs). Ensure that any table or platform on
which this product is installed can withstand the weight of the product. The table or
platform should have sufficient width and depth, and be robust enough not to easily
topple over.
Do not place this product on any unsteady surface or table. Do not place on slanted
areas, unstable areas, or areas where vibration is present.
Physical damage or personal injury may result if this product falls from an unsuitable
surface.
Place this product completely and securely on a level, stable surface. Do not allow any
portion of the display stand base to protrude from the installation surface. Otherwise,
Cintiq may fall and cause physical damage or personal injury.
Use care when adjusting the working position. Use a smooth, horizontal motion when
pulling Cintiq toward you. Do not lift the stand from the desktop. You can move the
stand base to align with the edge of your desktop. DO NOT let the stand base protrude
over the desktop.
If you pull too far, and as as the front of the stand moves over the edge of your desktop,
the friction of the base pads will increase and "lock" the stand in place. Do not pull
beyond this point or past the base pads. Push the display stand back onto the working
surface until the front edge of the stand base aligns with the edge of the installation
surface.
Contents
7
7