Table of Contents
Advertisement
INSTALLATION
Installation
1. Remove the packing tape and clean up.
Remove all the tapes that are securing the doors and the inner attachments. Open the doors for ventilation.
If the outer panels are dirty, wet a cloth with a diluted neutral detergent and wipe them. (Undiluted
detergent can damage the plastic components. For the dilution, refer to the instruction of the detergent.)
Wipe off the residual detergent with a wet cloth and then wipe off any moisture.
Note: Remove the cable tie banding the power supply cord. Prolonged banding may cause the corrosion
of the cord coating.
WARNING
Do not leave the plastic wrapping bags within reach of children. If the bag is placed over a child's
head, it can block the mouth and nose and cause suffocation.
2. Connecting a gas injection nozzle.
In the case of control of O
density in the chamber, connect the gas injection nozzle to the gas injection
2
port by using the gas injection nozzle tube enclosed (inner diameter; 5 mm, outer diameter; 9 mm, length;
210 mm) (Fig. 1). This helps faster recovery of humidity after opening of the inner door.
Gas injection port
Gas injection nozzle tube
Gas injection nozzle
Fig.1
18
Advertisement
Table of Contents
