Location Requirements - Hisense AW-08TW1RAFUE20 Use And Installation Instructions

Before You Begin
Read these instructions completely and carefully.
■ IMPORTANT:
Save these instructions for local inspector's use.
■
IMPORTANT: Observe all governing codes and ordinances.
■ Note to Installer: Be sure to leave these instructions with the
consumer.
■
Note to Consumer: Keep these instructions for future
reference.
■ Skill level: Installation of this appliance requires basic
mechanical skills.
■
Completion time: Approximately 1 hour.
We recommend that two people install this product.
■
■ Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
■
covered under the Warranty.
You MUST use all supplied parts and use proper
■
installation procedures as described in these
instructions when installing this air conditioner.
IMPORTANT: Observe all governing codes and ordinances.
Check the location where air conditioner will be installed. Proper
installation is your responsibility. Make sure you have everything
necessary for correct installation.
The location should provide:
■
Do not use an extension cord.
The appliance shall be installed in accordance with
national wiring regulations.
Free movement of air in room to be cooled.
■
A large enough opening for the air conditioner.
■
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass through the cabinet louvers freely.
Cooling models without Cabinet
louvers on top
A

Location Requirements

.
A Cabinet louvers
Window Installation
Window opening measurements:
These instructions are for a standard double h - ung
window. You will need to modify them for other
types of windows.
The air conditioner can be installed without the
side curtain panels if needed to fit in a narrow
window. See the window opening dimensions.All
supporting parts must be secured to firm wood,
masonry or metal.
The electrical outlet must be within reach of the
power cord.
Follow the dimensions in the table and
illustration for your model.
Models
5K BTU DOE
12 2 /5" (315mm) min
6K BTU DOE
6K BTU E-star
8K BTU
13 3 /5" (345mm) min
10K BTU
12K BTU
15 1 /5" (386mm)
14K BTU
(
With side curtain panels
If AC is Blocked by Storm Window
Add wood as shown, or remove storm window before air.
conditioner is installed.
If storm window frame must remain, be sure the drain holes
or slots are not caulked or painted shut. Accumulated rain
water or condensation must be allowed to drain out.
Storm window
frame or other
obstruction.
5
A B
22 (559mm) - 37 4 "
24 1 /2" (622mm) - 39
min 24 9 /10" (632mm) - 39 (991mm)
A
B
)
sash
Board
1-1/2"min
thickness
(38 mm)
as required,
for proper
pitch to rear,
along entire
sill. Fasten
with nails or
screws.
/5" (960mm)
" (991mm)
"