Axminster AP340PD User Manual page 12

ASSEMBLY
Fig30
Cutout slot
6. Line up the two holes in the micro switch unit with the
threaded holes to the end of the angled bracket (6). Make
sure to introduce the micro switch cable into the cutout slot
in the mounting bracket (6). Secure the micro switch with two
M5 Phillips screws (18), see fig 31.
Fig 31
Micro switch unit
7. Undo the clamping knob to the side of the micro switch
sufficiently to allow the guard rail to slide up through the
centre of switch.
8. Locate the chuck guard and rail assembly (7). Turn the guard
over and slot the rail into the guard's mounting channel, insert
the two square clamps into the rail's 'T' slot and secure by
nipping up the Phillips screws. DO NOT OVERTIGHTEN to
avoid the plastic guard from cracking, see fig 32-33-34.
Fig 32-33-34
Square clamp
Housing
Micro switch
18
7
Rail
Clamping screws
9. Introduce the chuck guard rail (7) up through the centre of
the micro switch and nip up the clamping knob to lock the
chuck guard in place, see fig 35.
NOTE: You can re-adjust the guard's height for different
drilling operations.
Morse taper arbor and chuck
10. Locate the keyless chuck (11) and Morse taper arbor (12).
Insert the Morse taper arbor into the keyless chuck then slot
the assembly up into the quill until it's firmly home. Place a
piece of timber on the table, turn the lever feed handle (9)
down until the chuck is up against the timber and press
firmly down. The Morse taper (12) should now be locked
tight inside the quill, stopping the assembly from dropping
out, see fig 36-37-38.
12
Fig 35
7