Eneo ISM-72F0021W0A Full Manual page 24

MEGA-PIXEL NETWORK CAMERA
Full Menu Setup
> SPEED : Adjusts the zoom control speed. Increasing the value increases the speed.
> LENS LOCKING : Allows locking of the lens control to prevent undesirable operation.
• OFF : Disables the locking feature allowing lens operation at any time.
• ON : Locks and disables the lens operation immediately.
• TIMER : Locks and disables the lens operation after a certain period of time, as set
in LOCKING TIMER.
> LOCKING TIMER : Defines the amount of time before the lens is locked.
> LENS CALIBRATION : Calibrates and renews the lens data as setup at the Factory.
[ WARNING ]
LENS CALIBRATION is not necessary for regular installations.
LENS CALIBRATION would only be necessary should you not be able to focus the
lens after a zoom operation due to shock during transportation of the camera.
To perform LENS CALIBRATION;
- A fixed object with sharp edges should be at least 3 meters away in front of the
camera and should be stationary i.e. not moving. A plain wall is not suitable to
calibrate on.
- The camera must be placed firmly, without shock or vibration, during the calibration.
- Scene light level must be bright enough. Do not try calibration at night or in low-light.
- If the calibration fails, change the environment and try again.
> ENABLE DAY&NIGHT SYNC FOCUS : Enables refocusing whenever the day&night
changes. It is not recommended to use this feature as it may lose focus over the night
due to focusing failure at night.
> LENS INITIALIZE ON BOOT : Mark ENABLE checkbox to enable lens initializing
when camera is booting.
24