Table of Contents
Advertisement
Mounting standard metal fixtures (PDP-S03-LR)
2 ) Installing procedure
Install the speaker according to the procedure (1)
through (3) below:The illustrations below show the
speaker (for right) to be mounted to the right of
the display.
Caution:
When the speaker is mounted to the display, the
operation panel of the display cannot be used. A remote
controller supplied to the display should be used.
(1) Affixing the mounting plate to the speaker
Set the mounting plate to 0.5 to 1cm be-
low the top of the speaker.
Seal (2 places)
Mounting plate
U P
1. Make sure of right and left speakers by
confirming the indication of "Right" and
"Left" on the rear side. Set the mounting
plate to the corresponding speaker so
as to get a proper combination of
speaker and mounting plate.
2. Peel off two seals at the affixing plane
on the mounting plate.
3. Make sure of the position to be affixed
and affix the mounting plate to the side
of the speaker.
(Note) Attach mounting plates to speakers only when
speakers are to be mounted on to the display.
(2) Installing the metal fixture on the speaker
• Washers M8 ( φ 25) are supplied for third-party metal
fixtures.
• Mount commercial fixtures by the two-point mounting
method to the mounting holes provided at the center
or bottom of the back of the speaker. These mounting
holes are at different levels. To make the hole levels
even, use additional washers until they are flush.
Mounting metal
fixture (for upper
side)
U P
Countersunk screw
Metal fixture (for lower side)
126
Mounting plate
1. Since the upper metal
fixtures are distinguished
between right and left ones,
make sure of speakers and
right and left metal fixtures
properly before setting up.
2. Install the metal fixtures at
the position as shown in the
figure to the left.
(3) Installing the speaker to the side of the plasma
display
U P
Hexagon socket
screws
1. Remove the hole rivets (two places on a single side)
from the rear of the display (by turning the hole rivet
with a coin and so forth).
2. Make sure of right and left position by looking at the
indication of "Right" and "Left" on the rear side of the
speakers. With the "UP»" indication placed upward,
install the upper metal fixture first and then the lower
one on the display.
(To make allowance for clearance correction,
temporarily install the display.)
3. Adjust the position of the display so that the clearance
between the speakers and the display is even, then
fully tighten the screws.
• When you install the speakers, using
screws other than those provided may
cause the speakers to fall or malfunction.
Use only the screws provided for
Caution
installation.
• When the display is to be moved after
installing the speakers, do not hold the
speaker itself. Please move the display
by holding its lower side.
Plasma display
Hole rivet
Advertisement
Table of Contents
