Splitting A Network Into Two Networks - ZyXEL Communications PLA5000 Series User Manual

5.6 Splitting a Network into Two Networks

This section shows you how to split your existing network into two networks. This is useful if you want to set
up a second Powerline network in your home, for example, in your study connecting a laptop and
printer. See
To set up your existing Powerline network you had to set each Powerline adapter with the same network
name. To create a second (separate) Powerline network, configure the PLAs you want to add to the
second network with a new network name.
Connect a Powerline adapter to your computer and open the Zyxel PLA Series Configuration utility (see
1
Section 5.3 on page
The utility should open to the configuration tab as shown below. A list of Powerline adapters on your
2
network displays. These adapters all have the same network name as the adapter you are connected
to. The adapter you are connected to will appear as Local in this table. All others are listed as Remote.
Figure 27 Local/Remote Adapters on a Powerline Network
To set up a new Powerline network, type the DAK Password and change the Network Name on all
3
Powerline adapters you wish to add to your network.
• Look for the DAK Password on a label on your Powerline adapter. The DAK Password lets you
access the adapter.
• Select the Remote adapter you want to add (A) and type the DAK Password in the DAK
Password field (B).
• Then type the new network name in the Network Name field (C).
Chapter 5 Powerline Network Setup Tutorial
Figure 25 on page 40 for an example.
37).
PLA Series User's Guide
41