ZyXEL Communications PLA5000 Series User Manual page 45

The POWER light blinks two times quickly then pauses, before repeating.
The ENCRYPT process has failed. Press the RESET/ENCRYPT button on both devices for 5 to 8 seconds,
then try to reconnect. For models with separate buttons, press the ENCRYPT button for more than 10
seconds to release the connection.
The POWER lights on both devices blink when I press the RESET/ENCRYPT buttons, but the
HomePlug light does not turn on.
• Ensure you have pressed the RESET/ENCRYPT button on both devices.
• Wait for about a minute while the devices set up a connection.
• If that does not work, try again with both devices connected to a power strip next to each other. If
they now connect, then the devices were not on the same electrical circuit before.
The POWER lights on both devices blink, then many lights blink and the HomePlug light blinks red.
Do not worry, the connection process is proceeding normally.
The POWER lights on both devices finished blinking, but only one device's HomePlug light is on.
One device may have connected to a third Powerline device. To check device A is connected to
device B and not another device, disconnect device B from its power source. Device A's HomePlug
( ) light will turn off if the connection is with Device B. Press the RESET/ENCRYPT button on both devices
for 5 to 8 seconds (for models with separate buttons, press the ENCRYPT button for more than 10
seconds)., then try to reconnect, pressing the RESET/ENCRYPT button for 0.5 to 3 seconds on both
devices.
I pressed the RESET/ENCRYPT button for 5 to 8 seconds, but the HomePlug light is still on.
The HomePlug light is on, indicating it is still connected to another Powerline device. Try again, pressing
the RESET/ENCRYPT button for 5 to 8 seconds. For models with separate buttons, press the ENCRYPT
button for more than 10 seconds to release the connection.
Chapter 6 Troubleshooting
PLA Series User's Guide
47