JETWAY A210GDAG User Manual page 18

(8) High Definition Audio Connector: J1
This Connector are 6 phone Jack for LINE-OUT, LINE-IN, MIC, Surrback, Surround, GEN/LEF
Line-out : (GREEN)
Line-in : (BLUE)
MIC : (PINK)
Surrback : (ORANGE)
Surround : (BLACKNESS) Audio output to speaker-Center/Subwoofer speaker out
GEN/LEF: (GRAY)
(9) VGA Connector (15-pin D-Sub) Connector: VGA (for A210GDAG serial)
VGA is the 15-pin D-Subminiature female connector for display monitor.
(10) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(11) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
Audio output to speaker
Audio input to sound chip
Microphone Connector
Audio output to speaker-Rear speaker out
Audio output to speaker-Side speaker out
Line-IN
PS/2
PRINT
Mouse
PS/2
COM1 VGA/COM2
Keyboard
FDD
Pin 1
Floppy Drive Connector
13
Line-OUT
Surrback
USB2
GEN/LFE
LAN
USB
MIC-IN
SURROUND