Axis M4308-PLE User Manual page 13

AXIS M4308-PLE Panoramic Camera
Configure your device
7. Set the postbuffer time to 1 minute.
8. Click Save.
Record video when the camera detects loud noises
This example explains how to set up the camera to start recording to the SD card five seconds before it detects loud noise and
to stop two minutes after.
Turn on audio:
1. Set up the stream profile to include audio, see Add audio to your recording on page 17.
Turn on audio detection:
1. Go to System > Detectors > Audio detection.
2. Adjust the sound level according to your needs.
Create a rule:
1. Go to System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
4. In the list of actions, under Recordings, select Record video.
5. In the list of storage options, select SD_DISK.
6. Select the stream profile where audio has been turned on.
7. Set the prebuffer time to 5 seconds.
8. Set the postbuffer time to 2 minutes.
9. Click Save.
Provide visual indication of an ongoing event
You have the option to connect the AXIS I/O Indication LED to your network camera. This LED can be configured to turn on whenever
certain events occur in the camera. For example, to let people know that video recording is in progress.
Required hardware
• AXIS I/O Indication LED
• An Axis network video camera
Note
AXIS I/O Indication LED should be connected to an output port.
Note
For instructions on how to connect the AXIS I/O Indication LED, see the installation guide provided with the product.
The following example shows how to configure a rule that turns on the AXIS I/O Indication LED to indicate that camera is recording.
1. Go to System > Accessories > I/O ports.
2. Make sure that the port you connected the AXIS I/O Indication LED to is set to Output. Set the normal state to Circuit open.
3. Go to System > Events.
13