Match Light
1. If the burner will not light after several attempts
then the burner can be match lit. Before using the
match, turn the knobs clockwise to OFF and allow 5
minutes for any accumulated gas to dissipate.
2. Clip a match on one end of the lighting rod.
3. Light match.
4. Hold lighting rod and insert lighted match right next
to the burner ports on the designated burner. To
light the burners under the hotplate, first remove
the hotplate to allow accessibility of lighting rod
reaching the burner tube.
5. Push in and turn the designated control knob
anticlockwise to
6. Burner should ignite immediately.
NOTE: Once lit, burners can be adjusted between
HIGH and LOW settings as desired.
.
HIGH
3
Control Knob, Label
Main burner
Component Identification
Main Burners
OFF
2
Push In
LOW
11
Side burner
Side Burner