Axminster Professional AP350WL Original Instructions Manual page 11

To remove the Drive Centre (A), locate the push rod (C), while holding the tool insert the push rod (C)
through the centre hole of the headstock wheel and push the drive centre out. (See figs 15-16-17)
Repeat the procedure for the Live Centre in the tailstock. (See fig 18)
Figure 15
Centre hole in the headstock operating wheel
Figure 17
A
Removing the drive centre
Figure 18a
D
Loosen the two grub screws (D) on
either side of the faceplate boss
Access hole
Spindle collar
REMOVING DRIVE/LIVE CENTRES
Insert the push rod (C) through the
headstock and push the drive centre out
Live centre in tailstock
REMOVING THE FACEPLATE
Rotate the spindle until the machined hole on the
shaft lines up with the spindle collar access hole.
Insert the push rod (C) into the access hole, using a
Hex key loosen the two grub screws (D) on either
side of the faceplace boss. Place a spanner over
the faceplate boss and while holding the push rod
rotate the spanner anti-clockwise to remove the
faceplate,see fig 18a.
11
Figure 16
C
Figure 18