Device Backup; Dante Setup Dante Model - Yamaha DZR315-D Reference Manual



DEVICE BACKUP

Saves and loads the user settings to and from a USB flash drive.
Use this function when you want to set multiple DZR, DXS-XLF series devices to the same
setting configuration, or change to another DZR, DXS-XLF series device while retaining
the same settings.
q
w
q SAVE TO USB
Saves settings data to a USB flash drive.
Connect the USB flash drive to the USB terminal, and then select SAVE TO USB and
enter the file name. File names can be up to 16 characters long. Only half-width alpha-
numeric characters and some symbols are supported.
Turn the main knob to select the position to enter text, and then press the main knob to
enter text input mode. When in text input mode, turn the main knob to select a charac-
ter, and then press the main knob to enter the character.
NOTE
For more details on potential alert messages, see the
w RESTORE FROM USB
Loads settings files stored to a USB flash drive.
Connect the USB flash drive to the USB terminal, and then select RESTORE FROM
USB. A list of files stored to the USB flash drive will appear on the screen. Select the
file you want to load. Up to 20 files can be displayed on the screen.
NOTE
• Audio will be muted temporarily when settings are changed to avoid noise being output.
• For more details on potential alert messages, see the
• When changing file names on your computer, make sure the new file name is 16 characters or
less and only uses half-width alphanumeric characters or the following symbols: !, #, $, %, &, \',
(, ), +, ,, -, ., =, @, [, ], ^, _, `, {, }, (space). Note that you will not be able to load a file that does
not follow these naming conventions.
• Be aware that using RESTORE FROM USB will overwrite presets even if they are
protected (see page 15, " PROTECT").
"Message List" (page 37).
"Message List" (page 37).

DANTE SETUP Dante model
This screen is used to configure Dante settings and display the Dante network status.
q
w
e
r
t
y
u
q MODE (DANTE MODE)
Sets the mode used when connecting this product to the Dante network.
• STANDARD: Select this when not using the TF series Quick Config function.
• Quick Config: Select this when using the TF series Quick Config function.
NOTE
If there are multiple TF series devices on the Dante network, only select the TF series "with OUT-
PUT" check box for one device. Patches will not be applied correctly if multiple devices are
selected.
Screen Functions
Screen after scrolling
downwards
23