Electronically Controlled B...
6.1.3 ECB Drive or Bypass Selection
Use the LCP and display to switch between the motor running in drive mode or bypass when operating in local control. The
display in operating mode is shown below.
1. Press [Drive Bypass]. Display changes to show
bypass and drive mode options (shown in Step 2).
2. When running in drive mode, press [OK] on LCP
to activate bypass mode or press CANCEL to
remain in drive mode. In bypass, the motor will
run at full speed.
3. When running in drive mode, press [OK] on the
LCP to activate drive mode or press [Cancel] to
remain in bypass mode.
4. Press [Status] to return to drive status display.
NOTE!
Pressing [Info] at any time displays tips and guidelines for performing the function currently activated.
Vertical Bypass/Non Bypass Panel
®
MG.13.A1.22 - VLT
is a registered Danfoss trademark
1
2
3
1 = Display
2 = Info key
3 = Drive/Bypass Option Key
6
6
6-5