Electromechanical Bypass (E...
Fault Reporting Function Setup
•
Fault reporting status is connected to connector
X55, output terminals 5, 6, and 7.
5.1.9 EMB2 Switches
Mode selector switch.
A panel mounted Drive/OFF/Bypass/Test selector switch is
used to electrically select whether the motor is controlled
by the drive (M1 and M2 contactors), connected to the
full-speed bypass (M3 contactor), or disconnected from
both. The test position allows for operation in bypass while
5
5
providing power to the drive (M1 and M3). See Figure 1.2.
5-6
Vertical Bypass/Non Bypass Panel
®
MG.13.A1.22 - VLT
is a registered Danfoss trademark