Installing The Turbocharger - ABB A130-M65 Operation Manual

Operation Manual / 4 Product description / A130-M.. - A145-M..
2 Removing and Installing
2.3

Installing the turbocharger

2.3.1 Inserting gaskets
Inserting the gaskets
Damaged or improperly inserted gaskets lead to oil leaks.
Always use new gaskets and insert them carefully into the slot.

CAUTION
The oil is supplied (02) and drained (03) through the bracket (01).
The necessary sealing is by means of O-rings which are located in the slots of the bracket.
The gaskets are not included in the ABB Turbo Systems scope of delivery and must be
provided by the enginebuilder.
Figure 9: Inserting gaskets into the bracket
01 Bracket
02 Oil supply
03 Oil drain
Pin (06) as installation safety device
Turbochargers can have an oil inlet either on their right or left side; the oil
inlet position can be different for the turbocharger fitted on the left and on the
NOTICE
right engine bank.
A pin can be installed in the support as an installation safety device to
prevent inadvertent incorrect fitting. This pin fits into the respective slot on
the foot of the bearing casing. Instructions of the enginebuilder must be
observed.
© Copyright 2015 ABB. All rights reserved.
04 Slot for gasket
05 O-rings
06 Pin (optional)
HZTL4031_EN
Page 16 / 115
Revision C February 2016