Hisense AW-05CR1RUGU10 Use And Installation Instructions page 9

1. Center air conditioner in window. Lower the window sash
behind the top rail to hold cabinet in place.
Keep a firm grip on the air conditioner, place the unit into
the window opening carefully so the bottom of the air
conditioner frame is against the window sill and make sure
the unit is staying center of the window. Close the window
behind the top rail of the unit carefully.
NOTE: Your model may differ from the one shown.
2. Place the frame lock between the frame
extensions and the window sill with 3/4" (19mm)
screw as shown.
3. To secure lower sash in place, attach right angle
sash lock with 3/4" (19mm)
Window Air Conditioner Installation
About 3
Seal
screw as shown.
Attach Side Curtains to Window
1. Pull the left-hand curtain out until it fits into the window
channel.
2. Use a
1 /8" (3mm) drill bit to drill a starter hole through the
hole in the top rail.
3. Insert one of the 3 4
/ " (1
curtain and into the window sash.
A
B
C
A. Window sash
B. Hole in side curtain
C . 3/4"
NOTE: The following step 4 and step 5 are only
applicable for E-star models,with E-star LOGO on
the control panel.
4. Put one EVA Foam on the Curtain housing.
In order to minimize air leaks and ensure optimal
insulation, it is necessary to install the EVA Foam on
the Curtain housing.
After the unit is installed to the window, measure
the inner width of the side curtain as shown.
7
9mm ) screws through the left-hand
screw
Measure the inner width
of the side curtain