Positioning Of The Hob - Smeg SR64S Manual

Hide thumbs

Table of Contents

The following operation requires building and/or carpentry work so must

be carried out by a competent tradesman.

Installation can be carried out on various materials such as masonry,

metal, solid wood or plastic laminated wood as long as they are heat

resistant (T 90°C).

4.1

Create an opening with the dimensions shown in the figure in the top

surface of the counter, keeping a minimum distance of 50 mm from the

rear border.

This appliance is classified as "type Y" in relation to fire hazards and

can therefore be mounted against walls higher than the work surface on

condition that a certain distance "X" be kept between the appliance and

the wall as shown in the figure so as to avoid damage from

overheating.

Make sure there is a minimum of 750 mm between the hot plate flames

and any shelf that may be installed directly above them.

MOD

(mm)

min 110

Carefully position the insulating seal supplied on the outer perimeter of

the hole made in the counter top as shown in figure 4 (the dimensions

in the figure refer from the hole to the inside of the seal), trying to

ensure that it sticks across the whole of its surface by applying light

pressure with your hands. Fix the hob to the unit using the appropriate

brackets B and spacer A as shown in figures 1, 2 and 3. Spacer A will

help to keep the hob top at the right distance from the edge of the

counter top to avoid future overheating during operation and must be

used solely in the front left-hand corner of the appliance. Carefully

trim the surplus away from edge C beyond the seal (Fig.5).

Instructions for the installer