Advertisement
2
POSITIONING OF THE HOB
The following operation requires building and/or carpentry work so must
be carried out by a competent tradesman.
Installation can be carried out on various materials such as masonry,
metal, solid wood or plastic laminated wood, as long as they are heat-
resistant (T 90°C).
2.1
Create an opening with the dimensions shown in the figure in the work surface.
A (mm)
B (mm)
min 110
min 460
Carefully position the gasket provided all around the outer edge of the hole
in the work surface as shown in figure 2, pressing it down lightly to ensure
it adheres properly. The front and rear sides of the gasket must skim the
hole. Now place the hob on the insulating gasket and use the screws and
fixing brackets (fig. 4) to secure the hob to the supporting structure,
adjusting it until perfectly horizontal.
Carefully trim off the excess edge of the gasket C (Fig.3). The
dimensions in figure 2 below refer to the distance between the hole and
the inside edge of the gasket. Do not fit the brackets shown in fig. 4 until
the hob has been set in place.
22
Instructions for the installer
Attachment to support structure, traditional built-in
model
C (mm)
D (mm)
min 750
20÷50
E (mm)
L (mm)
min 50
700
X (mm)
Y (mm)
492
700
Advertisement
