Table of Contents
Advertisement
Quick Links
1. INSTRUCTIONS FOR USE..................................................... 26
2. SAFETY PRECAUTIONS........................................................ 28
3. ENVIRONMENTAL RESPONSIBILITY.................................... 30
4. USING THE HOB .................................................................... 31
5. CLEANING AND MAINTENANCE .......................................... 33
6. POSITIONING IN THE COUNTER TOP ................................. 36
7. ELECTRICAL CONNECTION ................................................. 38
8. GAS CONNECTION ................................................................ 39
9. ADAPTATION TO DIFFERENT TYPES OF GAS ................... 41
THESE INSTRUCTIONS ARE VALID ONLY FOR THE DESTINATION COUNTRIES
WHOSE IDENTIFYING SYMBOLS ARE INCLUDED ON THE COVER OF THIS
MANUAL.
INSTRUCTIONS FOR THE USER: these contain user advice, the description
of the controls and the correct procedures for cleaning and maintenance of
the appliance.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified
technician who must install the appliance, set it functioning and carry out
an inspection test.
Contents
25
Advertisement
Table of Contents
Related Manuals for Smeg Victoria SR975BGH
Summary of Contents for Smeg Victoria SR975BGH
-
Page 1: Table Of Contents
Contents 1. INSTRUCTIONS FOR USE............. 26 2. SAFETY PRECAUTIONS............28 3. ENVIRONMENTAL RESPONSIBILITY........30 4. USING THE HOB ..............31 5. CLEANING AND MAINTENANCE .......... 33 6. POSITIONING IN THE COUNTER TOP ......... 36 7. ELECTRICAL CONNECTION ..........38 8. GAS CONNECTION ..............39 9. -
Page 2: Instructions For Use
General instructions 1. INSTRUCTIONS FOR USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE. IT MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE YOU TO READ THIS MANUAL AND ALL THE INFORMATION IT CONTAINS CAREFULLY BEFORE USING THE HOB. - Page 3 General instructions ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE (OFF) POSITION WHEN YOU FINISH USING THE HOB. NEVER PLACE PANS WITH BOTTOMS WHICH ARE NOT PERFECTLY FLAT AND SMOOTH ON THE COOKING HOB RACKS. NEVER USE CONTAINERS WHICH PROJECT BEYOND THE OUTSIDE EDGE OF THE HOB.
-
Page 4: Safety Precautions
General instructions 2. SAFETY PRECAUTIONS REFER TO THE INSTALLATION INSTRUCTIONS FOR THE SAFETY REGULATIONS FOR ELECTRIC OR GAS APPLIANCES AND VENTILATION FUNCTIONS. IN YOUR INTERESTS AND FOR YOUR SAFETY IT HAS BEEN ESTABLISHED BY LAW THAT THE INSTALLATION AND SERVICING OF ALL ELECTRICAL APPLIANCES IS TO BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. - Page 5 General instructions DO NOT LET CHILDREN GO NEAR THE APPLIANCE WHEN IT IS IN OPERATION OR PLAY WITH IT AT ANY TIME. DO NOT INSERT POINTED METAL OBJECTS (CUTLERY OR UTENSILS) INTO THE SLITS IN THE APPLIANCE. DO NOT USE STEAM JETS FOR CLEANING THE APPLIANCE. THE STEAM COULD REACH THE ELECTRONICS, DAMAGING THEM AND CAUSING SHORT-CIRCUITS.
-
Page 6: Environmental Responsibility
Instructions for disposal 3. ENVIRONMENTAL RESPONSIBILITY Our environmental care Pursuant to Directives 2002/95/EC, 2002/96/EC, 2003/108/EC, relating to the reduction of the use of hazardous substances in electrical and electronic appliances, as well as to the disposal of refuse, the crossed out bin symbol on the appliance indicates that the product, at the end of its useful life, must be collected separately from other refuse. -
Page 7: Using The Hob
Instructions for the user 4. USING THE HOB Before turning on the burners, make sure that the burners, flame-spreader crowns and racks are fitted correctly. In the ultra-rapid burner, notch A must be aligned with pin B. Lighting the burners The burner controlled by each knob is shown next to the knob. - Page 8 Instructions for the user Practical tips for using the burners For better burner performance and minimum gas consumption, pans with flat, even bases and with lids should be used, and their size should be in proportion to the burner (see “4.3 Pan diameters”). During cooking, in order to avoid burns or damage to the hob top and to the glass lid (when present), all pans or griddles must be positioned within the cooking hob...
-
Page 9: Cleaning And Maintenance
Instructions for the user 5. CLEANING AND MAINTENANCE Important: DO NOT USE STEAM JETS FOR CLEANING THE HOB. Before performing any operations requiring access to powered parts, disconnect the appliance from the power supply. Cleaning the hob To keep the hob in good condition it should be cleaned regularly after use. Let it cool first. - Page 10 Instructions for the user Cleaning the components 5.2.1 Knobs The knobs should be cleaned with lukewarm water and washing up liquid. For easier cleaning they can be removed by pulling them upwards. Dry thoroughly after cleaning. Do not use aggressive products containing alcohol or products for cleaning steel and glass when cleaning the knobs, as these products could cause permanent damage.
- Page 11 Instructions for the user 5.2.5 Lid (on some models only) Clean the glass or steel lid, where mounted, with lukewarm water. Never use abrasive sponges or detergents. To clean the rear part of the cooktop, remove the lid unit by lifting it upwards. When finished cleaning, refit the cover making sure to insert it correctly.
-
Page 12: Positioning In The Counter Top
Instructions for the installer 6. POSITIONING IN THE COUNTER TOP The following operation requires building and/or carpentry work so must be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C). - Page 13 Instructions for the installer In case of installation on an empty kitchen unit with doors, a separation panel must be placed under the hob. Keep a minimum distance of 10 mm between the bottom of the hob and the surface of the panel, which must be easily extractable to allow sufficient access for any technical assistance.
-
Page 14: Electrical Connection
Instructions for the installer 7. ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power line conform to the data shown on the plate located under the casing. Do not remove this plate for any reason. The plug at the end of the supply cable and the wall socket must be of the same type and must conform to the applicable legislation on electrical installations. -
Page 15: Gas Connection
Instructions for the installer 8. GAS CONNECTION If the appliance is installed on an oven, you must avoid running the gas tube round the back of the oven in order to avoid overheating. Connection to the gas supply network can be made using a rigid copper hose or a flexible steel hose with a continuous wall and in compliance with the guidelines established by the applicable standard. - Page 16 Instructions for the installer Connection to LPG Use a pressure regulator and make the connection on the gas cylinder following the guidelines set out in the regulations in force. Make sure that the supply pressure complies with the values indicated in the paragraph “3.2 Burner and nozzle characteristics tables”.
-
Page 17: Adaptation To Different Types Of Gas
Instructions for the installer 9. ADAPTATION TO DIFFERENT TYPES OF GAS Before carrying out the following operations, disconnect the appliance from the power supply. The cooker hob is preset for natural gas G20 (2H) at a pressure of 20 mbar. If other types of gas are to be used, the nozzles must be replaced and the primary air must be adjusted. - Page 18 Instructions for the installer Adjustment for LPG Loosen screw A and push support B all the way. Using a a double head, remove nozzle C and replace it with the appropriate nozzle, following the instructions in the tables for the type of gas to be used. The nozzle tightening torque must be no more than 3 Nm.
- Page 19 Instructions for the installer Adjustment for city gas Carry out the same steps as described in “9.2 Adjustment for LPG”, but select the nozzles and adjust the primary air for city gas as indicated in the table below and in "9.5 Primary air adjustment”.
- Page 20 Instructions for the installer Primary air adjustment Refers to distance “X” in mm. G30/G31 G110 BURNER 28/37 mbar 20 mbar 8 mbar Auxiliary (1) Semi-rapid (2) Medium rapid (3) Large Rapid (4) 10.0 Ultra-rapid (5) Internal (6) Double crown External (6) 10.0 Fish burner To identify the burners on your hob, refer to the drawings in “9.7 Arrangement of the burners on the...
- Page 21 Instructions for the installer 9.6.2 Adjusting the minimum setting for LPG To adjust the minimum setting with LPG, you must tighten the screw inside or next to the tap rod (depending on the model) fully in a clockwise direction. The bypass diameters for each individual burner are shown in table “9.2 Adjustment for LPG”.
- Page 22 Instructions for the installer Arrangement of the burners on the cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Medium Rapid 4. Large Rapid 5. Triple crown ultra-rapid 6. Double crown ultra-rapid 7. Fish burner Lubrication of gas taps Over time the gas taps may become difficult to turn and get blocked. Clean them internally and replace the lubrication grease.