Safety Precautions - Smeg SR64S Manual

General instructions
2

SAFETY PRECAUTIONS

REFER TO THE INSTALLATION INSTRUCTIONS FOR THE SAFETY
REGULATIONS FOR ELECTRIC OR GAS APPLIANCES AND
VENTILATION FUNCTIONS.
IN YOUR INTERESTS AND FOR YOUR SAFETY THE LAW
REQUIRES THAT THE INSTALLATION AND SERVICING OF ALL
ELECTRICAL APPLIANCES IS CARRIED OUT BY QUALIFIED
PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN
FORCE.
OUR APPROVED INSTALLERS GUARANTEE A SATISFACTORY
JOB.
GAS OR ELECTRICAL APPLIANCES MUST ALWAYS BE
DISCONNECTED BY SUITABLY SKILLED PEOPLE.
BEFORE CONNECTING THE APPLIANCE TO THE POWER GRID,
CHECK THE DATA ON THE PLATE AGAINST THE DATA FOR THE
GRID ITSELF.
THE IDENTIFICATION PLATE CONTAINING THE TECHNICAL DATA,
SERIAL NUMBER AND BRAND NAME IS IN A VISIBLE POSITION
UNDER THE CASING.
DO NOT REMOVE THIS PLATE ON THE CASING FOR ANY REASON.
BEFORE CARRYING OUT INSTALLATION/MAINTENANCE WORK,
MAKE SURE THAT THE APPLIANCE IS NOT CONNECTED TO THE
POWER GRID.
THE PLUG TO BE CONNECTED TO THE POWER SUPPLY CABLE
AND ITS SOCKET MUST BE OF THE SAME TYPE AND CONFORM
TO THE REGULATIONS IN FORCE.
THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS
BEEN BUILT IN. NEVER DISCONNECT THE PLUG BY PULLING ON
THE CABLE.
IF THE POWER SUPPLY CABLE IS DAMAGED, CONTACT THE
TECHNICAL SUPPORT SERVICE IMMEDIATELY AND THEY WILL
REPLACE IT.
IT IS OBLIGATORY FOR ALL ELECTRICAL EQUIPMENT TO BE
EARTHED ACCORDING TO THE METHODS LAID DOWN BY SAFETY
REGULATIONS.
30