Table of Contents
Advertisement
Setting terminal parameters
To configure and manage the AP through the console port, you must run a terminal emulator
program, Super Terminal or PuTTY, on your PC. You can use the emulator program to connect a
network device, a Telnet site, or an SSH site. For more information about the terminal emulator
programs, see the user guides for these programs.
The following are the required terminal settings:
•
Bits per second—9,600.
•
Data bits—8.
•
Stop bits—1.
•
Parity—None.
•
Flow control—None.
Powering on the AP
After the console cable is correctly connected, power on the AP. The following AP startup
information will be displayed on the configuration terminal:
System is starting...
Booting Normal Extend BootWare.
......
System application is starting...
Startup configuration file does not exist.
User interface con0 is available.
Press ENTER to get started.
At the prompt, press Enter to configure the AP.
Logging in to the AP through Telnet or the Web
interface
Telnet and Web access are enabled by default. The default username, password, and management
IP address of VLAN-interface 1 are admin, h3capadmin, 192.168.0.50/24, respectively.
If the IP address has been changed, please contact your network administrator to obtain the new IP
address.
3-2
Advertisement
Table of Contents
