H3C WA5320X-E Installation, Quick Start

H3C WA5320X-E Access Point Installation Quick Start-6W104
H3C WA5320X-E无线接入点 快速安装指南-6W104
Tool list 工具参考
The installation tools are not provided with the AP. Prepare them yourself as required.
AP不随机提供安装工具，请用户根据实际安装需求自己准备安装工具。
Phillips screwdriver Allen wrench
十字螺丝刀 内六角扳手
Heat gun Crimping tool
热风枪 压线钳
Installation accessories 安装附件介绍
M5×15 screw M6×30 screw
M5×15螺钉 M6×30螺钉
Band clamp Liquid-tight adapter PoE injector (optional)
喉箍 防水接头
PoE注入器（选配）
Needle-nose pliers Wire stripper
尖嘴钳
Network cable tester
测线仪
AP bracket Articulating arm Wall/Pole bracket
安装件1 安装件2
Grounding cable Expansion bolt
(user supplied) (user supplied)
接地线(用户自备) 膨胀螺栓（用户自备）
Attaching the AP bracket to the AP 安装设备安装件
Keep the pneumatic valve closed on the AP. Do not open it.
请勿拆开设备的排气阀。
Pneumatic valve 排气阀
剥线钳
Ladder
梯子
Use M6 screws to attach the articulating arm to the AP bracket.
通过M6螺钉将安装件2固定到安装件1上。
Mounting the AP on a wall 壁挂安装
Mark four screw hole locations on the
wall and drill holes with a depth of 8 mm
安装件3
( 0 . 3 2 i n ) a t t h e m a r k e d l o c a t i o n s .
Hammer expansion bolts into the holes
and remove the nut and washers from
each bolt.
在墙面标记安装孔位置，用冲击钻在标记
处打四个直径8mm的孔，并用橡胶锤将
膨胀螺栓敲入安装孔，拧下螺母和垫片。
Align the AP bracket with the screw holes in the rear of the AP. Use M5
screws to attach the AP bracket to the AP.
将安装件1对准设备背部的螺孔，通过M5螺钉把安装件1固定到设备。