Table of Contents
Advertisement
Setting parameters for the configuration terminal
To configure and manage the AP from the console port, you must run a terminal emulator program,
such as TeraTermPro, on your configuration terminal. You can use the emulator program to connect
a network device, a Telnet site, or an SSH site. For more information about the terminal emulator
programs, see the user guides for these programs.
Configure the terminal parameters as follows:
•
Bits per second—9,600.
•
Data bits—8.
•
Parity—None.
•
Stop bits—1.
•
Flow control—None.
Logging in to the AP from the console port
Verify that the AP is connected correctly to the configuration terminal and the configuration terminal
parameters are configured correctly. Then power on the AP. You can see the following information
on the configuration terminal:
System is starting...
Booting Normal Extend BootWare.
......
System application is starting...
Startup configuration file does not exist.
User interface con0 is available.
Press ENTER to get started.
Login from the Web interface or through Telnet
By default, you can log in to the device from the Web interface or through Telnet. The following
default login information is defined for your login:
•
Username—admin.
•
Password—h3capadmin.
•
Management IP address of VLAN-interface 1—192.168.0.50 with subnet mask
255.255.255.0. If the default IP address has been changed, contact the administrator to get
the new IP address.
3-2
Advertisement
Table of Contents
