Table of Contents
Advertisement
USING THE PROJECTOR
¾ Blend Gamma: Set the blend gamma. Options include: 1.8, 2.0, 2.2 (default), 2.4, and 2.6.
‡
Reset: Return the factory default settings for geometric correction settings.
Signal
Adjust the signal options.
‡
Automatic: Configure automatically the signal (the frequency and phase items are grayed out). If
automatic is disabled, the frequency and phase items will appear for tuning and saving the settings.
‡
Frequency: Change the display data frequency to match the frequency of your computer's graphic
card. Use this function only if the image appears to flicker vertically.
Phase: Synchronize the signal timing of the display with the graphic card. If the image appears to be
‡
unstable or flickers, use this function to correct it.
‡
H. Position: Adjust the horizontal positioning of the image.
‡
V. Position: Adjust the vertical positioning of the image.
Note:
This menu is only available if the input source is RGB/Component.
PIP/PBP
Display an image with two sources in PIP mode or PBP mode.
Note:
PIP/PBP function does not support 3D.
‡
Screen: Toggle between displaying two sources at once (Main and PIP/PBP images) or one source
only.
None: Display image from the main source only.
¾
PIP: Display images from two sources by separating the screen into two parts. One source is
¾
displayed on the main screen and another source is displayed in an inset window.
PBP: Display images from two sources by separating the screen into half. One source is
¾
displayed on the left side of the screen and the other source on the right side of the screen.
‡
PIP Location: Set the PIP location from top left, top right, bottom top, and bottom right.
‡
PBP Location: Set the PBP location from main left, main top, main right, and main bottom.
‡
Size: Set the PIP sub source size from Large, Medium, and Small.
Main Source: Select an active input to be used as the main image. The available inputs include HDMI
‡
1, HDMI 2, VGA, HDBaseT, USB, and Home.
‡
Sub Source: Select an active input to be used as the sub image. The available inputs include HDMI 1,
HDMI 2, VGA, HDBaseT, USB, and Home.
‡
Swap: Change the location of the PIP/PBP, and the PIP/PBP to main image. Swapping is available
only when PIP/PBP is enabled.
Note:
A)
PIP/PBP compatibility table as described below:
Sub
1. Flashing lines may occur if the bandwidth of both inputs are too high, please try to reduce the
42
English
PIP/PBP
VGA
VGA
-
HDMI 2
v1.4
v
v1.4
v
HDMI 1
v2.0
-
HDBaseT
v
USB
-
resolution.
Main
HDMI 2
HDMI 1
v1.4
v1.4
v2.0
-
-
-
-
v
v
v
-
-
-
-
-
v
v
v
-
-
-
HDBaseT
USB
-
-
v
v
v
v
-
-
-
v
-
-
Advertisement
Table of Contents
