Optoma ZU720TST User Manual page 15

INTRODUCTION
No Item
9. Home
10. Volume +/-
11. Information
12. Freeze
13. VGA
14. HDMI1
15. HDBaseT
16. USB
17. Focus
18. Zoom
19. Network
Numeric Keypad
20.
(0~9)
21. 3D
22. Format
23. HDMI2
24. Mode
Remote ID / Remote
25.
All
26. Digital Zoom +/-
27. Re-Sync
Laser
28.
29. Enter
30. AV Mute
Function Button (F2)
31.
(Assignable)
32. PIP/PBP Menu
33. Power Off
Note:
Some keys may have no function for models that do not support these features.
Press " " to switch to the launcher home.
Adjust to increase / decrease the volume.
Display the projector information.
Pause the screen image. Press again to resume the screen image.
Press "VGA" to switch to the VGA IN source.
Press "HDMI1" to switch to the HDMI 1 source.
Press "HDBaseT" to switch to the HDBaseT source.
Press "USB" to switch to the USB source.
Press "Focus" and or
projected image (Support Short Throw model only).
Press "Zoom" and or
image size (image (Support Short Throw model only).
Press "Network" to configure network settings.
Use as numeric keypad number "0~9".
Press "3D" to switch to the 3D source.
Press "Format" to set different aspect ratio.
Press "HDMI2" to switch to the HDMI 2 source.
Press "Mode" to select the display mode.
Press and Hold Remote ID key for 3 Sec into ID setting mode, than enter numeric
keypad to set Remote ID.
Zoom in/out the projected image.
Automatically synchronize the projector to the input source.
Point the remote control at the screen, press and hold the "laser" key to activate the
laser light.
WARNING: Do not look at the laser when it is active. Avoid pointing the laser
at your eyes.
Confirm your item selection.
Press "AV Mute" to momentarily turn off/on the audio and video.
Press "F2" to activate a function.
Press "PIP/PBP" to launch PIP/PBP menu.
Refer to the "Powering On / Off the Projector" section on page 25-27.
Item
buttons on the remote control to focus the
buttons on the remote control to zoom the projected
15
English