Table of Contents
Advertisement
USING THE PROJECTOR
Powering Off
1.
Turn off the projector by pressing the " " button on the projector keypad or the
remote control. The following message will be displayed:
2.
Press the
When you press the
3.
During the cooling cycle, the power LED is flashing green. When the power LED turns solid red,
this indicates the projector has entered standby mode. If you wish to turn the projector back on, you
must wait until the cooling cycle has finished and the projector has entered standby mode. When the
projector is in standby mode, simply press the " " button on the projector or the remote control again
to turn on the projector.
4.
Disconnect the power cord from the electrical outlet and the projector.
Note:
‡
It is not recommended that the projector is turned on immediately, right after a power off procedure.
‡
By default, the projector turns off automatically after 20 minutes of inactivity. You can modify the idle
time length in "Auto Power off (min.)" menu in "System Settings Power" . If you want the projector to
enter standby mode instead, disable auto power off and set the sleep time interval in "System Settings
Power Sleep Timer (min.)".
or
button again to confirm, otherwise the message will disappear after 15 seconds.
or
button for the second time, the projector will shut down.
button on the
27
English
Advertisement
Table of Contents
