Table of Contents
Advertisement
Coaxial (good)
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the coaxial out jack
on the cable or satellite box.
4 Plug your TV's power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press
or
to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See
page 53.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
waves.
• Do not bundle the coaxial cable with the power cord or other cables.
www.insigniaproducts.com
Cable or
satellite box
Back of TV
Automatically scanning for channels
19" 720p 60Hz LED TV
Cable
wall jack
Coaxial cable
on
21
Advertisement
Table of Contents
