Table of Contents
Advertisement
Coaxial (good)
On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected devices are turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on your TV and to the coaxial out jack on the cable
or satellite box.
4 Plug your TV's power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press
or
to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See
page 46.
Notes
Cable or
satellite box
Coaxial cable
Cable wall
jack
• Use a coaxial cable to eliminate interference and noise from radio
waves.
• Do not bundle the coaxial cable with the power cord or other cables.
www.insigniaproducts.com
Side of TV
Automatically scanning for channels
32" 720p 60Hz LED TV
on
15
Advertisement
Table of Contents
