Installing & Cleaning Cartridge Filter - Vacmaster VFB511B 0201 Operator's Manual

INSTALLING & CLEANING CARTRIDGE FILTER
1 2
INSTALLING CARTRIDGE FILTER
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Remove the power head and place in an upside down position.
3. Install the cartridge filter over the filter cage making sure the cage is completely covered (Fig. 2
& 3).
4. Place the filter retainer on the top of the cartridge filter over the raised lip and tighten down by
turning the retainer clockwise; do not over-tighten (Fig. 4 & 5).
5. Place the power head back onto the collection tank.
REMOVING & CLEANING CARTRIDGE FILTER
1. Unlock and remove the filter retainer by turning the retainer handle counter clockwise.
2. With the removed power head in an upside down position, carefully remove the cartridge filter
from the filter cage (Fig. 6).
3. Clean the cartridge filter by gently tapping or brushing dirt off. Cleaning should not be done
indoors in living areas. For optimal performance a new filter is recommended.
4. Install cleaned or new filters as above in steps 2-4 of Installing Cartridge Filter.
5. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
IMPORTANT! Clean or change the cartridge filter regularly for best performance.
ALWAYS USE THE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without
the cartridge filter, the motor will burn out and the warranty will be voided. Always keep spare filters
on hand.
WARNING:
BEFORE REMOVING THE POWER HEAD FROM THE COLLECTION TANK.
3
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
4 5
13
6