Blower Operation - Vacmaster VFB511B 0201 Operator's Manual

1 2
7
8
This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Remove the hose from the vacuum port. Remove the noise diffuser from the blower port.
4. Secure the larger end of the hose into the blower port on the back of the power head (Fig. 2).
5. Fit the desired attachment onto the hose or extension wand (Fig. 3).
6. Verify that the power switch is in the 'O' OFF position before plugging the power cord into the
outlet. Plug the power cord into the outlet (Fig. 4 & 5).
7. Before turning on the vacuum, firmly hold onto the loose end of the hose. Turn the motor on by
flipping the switch to the 'I' ON position (Fig. 6).
8. The unit will now blow through the vacuum hose and can be used to clear obstructions within
the hose (Fig. 7).
9. Once you have completed blowing, flip the power switch to the 'O' OFF position and unplug the
power cord from the outlet (Fig. 8).

BLOWER OPERATION

3
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
5
4
11
6