Table of Contents
Advertisement
en Basic operation
Push in the detergent drawer.
4.
Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start / Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
a After the programme has ended,
the display shows: End.
Soaking laundry
You can soak the laundry before
washing in the appliance by pausing
the programme.
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
load.
To resume the programme, after
3.
the desired soaking time, press
Start / Reload.
Adding laundry
Notes
¡ Please read the safety information
→ Page 4 to ensure that you use
the appliance safely.
¡ If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
36
Press Start / Reload.
1.
The appliance is paused and
checks whether it is possible to
add or remove laundry. Take note
of the programme status.
→ "Display", Page 20
Add or remove laundry.
2.
Close the door.
3.
Press Start / Reload.
4.
Cancelling the programme
Once the programme has started,
you can cancel it at any time.
Notes
¡ Please read the safety information
→ Page 4 to ensure that you use
the appliance safely.
¡ If you cancel a programme with
active oxygen, the door will remain
locked for up to 25 minutes until
there is no longer any active oxy-
gen in the drum.
while the active oxygen is being re-
moved. The door is then unlocked.
Press Start / Reload.
1.
Open the door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high: Start
the Spin or Drain programme.
Remove the laundry.
3.
Resuming the programme when
the programme status is Rinse
Hold
Set the Spin or Drain programme.
1.
Press Start / Reload.
2.
and
flash
Advertisement
Table of Contents
