Table of Contents
Advertisement
en Home Connect
Carry out the steps in the
7.
Home Connect app to connect the
appliance.
a If the display shows and
up permanently, the appliance is
connected to the home network.
If the display shows Err, the appli-
8.
ance is not connected to the home
network.
Check whether your appliance is
‒
in range of your home network.
Reconnect the appliance to the
‒
WLAN home network (Wi-Fi)
with WPS function.
Connect your appliance to the
9.
Home Connect app → Page 40.
Connecting your appliance to
the Home Connect app
Requirements
¡ The appliance is connected to the
WLAN home network (Wi-Fi).
¡ The Home Connect app is open
and you have logged on.
Set the programme to position 3.
1.
a The display shows .
Press Start / Reload.
2.
a The appliance connects to the
Home Connect app.
Once your appliance is displayed
3.
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a If the display shows , the appliance
is connected to the Home Connect
app.
Connecting the appliance to the
energy manager
If you connect the appliance to the
smart energy system (energy man-
ager), you will optimise your energy
consumption. The appliance starts
40
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
lights
Requirements
¡ The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡ You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
Press and hold Remote Start
1.
approx. 3 seconds.
a The display shows Aut.
Set the programme to position 7.
2.
a The display shows EnG.
Press Start / Reload.
3.
a The appliance is connected to the
smart energy system (energy man-
ager).
a If the appliance has connected to
the energy manager successfully,
the display shows and .
Activate Flex Start if you want the
4.
smart energy system (energy man-
ager) to start up your appliance.
→ "Activate Flex Start", Page 40
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement: The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
Set the programme you require.
1.
Press - Ready In + to set the re-
2.
quired time.
Press Start / Reload.
3.
for
Advertisement
Table of Contents
