4-1.Installation Of A Bracket - NEC N8103-104A User Manual

4-1.Installation of a Bracket

A full height PCI bracket is attached to this product at factory shipment. If you insert this product in a
low profile PCI slot, you have to replace the bracket with a low profile one that comes with this
product.
Tips
1. Remove the two screws of the external SAS connector.
2. Remove the two screws.
3. Remove the bracket from this product.
4. Install the low profile bracket to this product.
5. Tighten the two screws.
6. Tighten the two screws for the external SAS connector.
Tips
Notice
Exchange of a bracket uses the cross slot screwdriver and the nut driver suitable
for the size of a screw.
Follow the same procedure when the low profile bracket is replaced with the
standard bracket.
Make sure to keep the removed bracket carefully.
- 29 -