Troubleshooting - Summit ASDR1524 User Manual

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM
Appliance is not connected to a power
Appliance supply.
does not The appliance is turned off.
operate. Tripped circuit breaker or blown fuse
The temperature is not set correctly.
The ambient temperature could require a
lower temperature setting.
Drawers were opened too often.
Appliance is
not cold
A drawer was not closed completely.
enough.
Drawer is not hermetically sealed.
The condenser is too dirty.
The ventilation opening is blocked or too
dusty.
The room temperature is higher than
average.
A large amount of food has been added to
Appliance the unit.
turns itself on
and off Drawers are opened too often.
frequently.
A drawer is not closed completely.
A drawer gasket does not seal properly.
Appliance is not connected to a power
supply.
The light does Tripped circuit breaker or a blown fuse.
not work.
The light was switched off on the control
panel.
The appliance is not properly leveled.
Vibrations
The rattling noise may come from the flow of the refrigerant, which is normal. As each
cycle ends, you may hear gurgling sounds caused by the flow of refrigerant in your
The appliance
appliance.
seems to
If temperature fluctuations occur, the contraction and expansion of the inner walls
make too
may cause popping and crackling noises.
much noise.
The appliance is not properly leveled.
The appliance is not properly leveled.
Drawers
will not close The gaskets are dirty.
properly. The racks or bins are out of position.
Display "E0", "E0" indicates a communication error for 3
"E1". "E2",
zone models.
"E3", "E4", "E1" or "E2" indicates that the air

TROUBLESHOOTING

POSSIBLE CAUSE
Connect the appliance.
Switch on the appliance.
Switch on circuit breaker or replace
fuse.
Check the set temperature.
Set a lower temperature.
Do not open drawers more often than
necessary.
Close drawer properly.
Check the seal and clean or replace.
Clean the condenser when necessary.
Clear the obstructions and clean off the
dust.
Put the appliance in a cooler place.
Leave the appliance to work for a while
until the set temperature has been
reached.
Do not open the drawers more often
than necessary.
Close drawer properly.
Check the drawer seal and clean or
replace it.
Connect the appliance.
Switch on circuit breaker or replace
fuse.
Switch on the light.
Level the appliance with the adjustable
feet.
Level the appliance with the adjustable
feet.
Level the appliance with the adjustable
feet.
Clean the drawer gaskets.
Check the racks and bins and refit
correctly.
Call for service.
18
REMEDY