Table of Contents
Advertisement
FRYMASTER FPHD65 SERIES GAS FRYERS
3.1 Installing the Fryer
Decathlon 65 Series fryer systems are shipped in sections. The fryers are uncrated, removed from
pallets and assembled together. Important aspects during assembly include aligning and connecting
the drain system, oil return system, rinse-line system (where applicable), oil-return switch wiring
harness and fryer cabinets. Slight modifications to connecting hardware may be required when
assembling the system. The instructions below provide step-by-step instructions to assist the
installer in assembly.
Figure 1: Remove pallet
supports (arrow) before removing
fryers from pallets.
Figure 3: Connecting drain safety
wiring.
1. Open the doors of the filtration fryer cabinet. Remove filter pan from the cabinet. Uncrate fryers and remove
the pallet supports. Install ramps and slowly roll the fryer(s) off the pallets. See Figure 1.
2. Remove covers over openings in the cabinet to access the oil return and drain plumbing as well as safety drain
wiring also in the rear opening.
3. Remove the lower back from the two-vat unit and to gain access to the oil return line.
4. Remove the right-side door from the larger unit, which allows access to the drain manifold.
5. With the fryer near its installation site, roll the two pieces to within a few inches of each other. Do not connect
the fryers to power.
6. Connect the color-coded drain wiring with the attached connector. The wiring is accessible in the oil return
opening at the rear of the fryer. See Figure 3.
7. Position the flex return line and roll the units closer together. The flex hose should align with the threaded
nipple.
8. Connect the flex line and tighten.
CHAPTER 3: INSTALLATION
Figure 4: Align the fryers and secure the
center mounting plate with bolts.
3-1
Figure 2: A
center-mounted
caster and its
extended
mounting plate is
shown at left.
The other
section of the
fryer is lifted
onto the plate
and secured with
provided bolts.
Advertisement
Table of Contents
