Tools Required - NINCOAIR GLIDER SPORT ARF Manual

NH92011 RTF – NH92012 ARF GLIDER SPORT

3. TOOLS REQUIRED

-Scissors
-Glue
-Pliers
-Crosshead screwdriver
-Allen wrench 3mm
4. INSTALLATION OF TAIL WING SET
1. Tear off double sided tape.
2. Hold horizontal stabilizer, pin the bulge into the concave. See attachment for rudder installation.
Insert the rudder from blade into the fuselage, secure both with glue.
3. Be sure to keep horizontal stabilizer balance at both side and the rudder should be vertical with
horizontal stabilizer.
4. Using foam glue or other suitable glue to reinforce.
5. Connect the throttle on the fuselage to horizontal stabilizer and rudder driver arms, secure with
allen wrench.
5. INSTALLATION OF MAIN WING SET
1. Insert main wing reinforce stick into one half wing.
2. Put stick through fuselage and connect another half wing, before the two half wings fully connected
together with fuselage, aileron servo (under main wing), and fuselage (the part on fuselage where two
half wings join) should be connected first.
3. Connect one end of aileron throttle to the servo arm (outmost hole), and connect another end to
aileron control arm, secure with wrench.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
10